| JaLCDOI | 10.18926/15354 |
|---|---|
| FullText URL | Mem_Fac_Eng_OU_34_1.pdf |
| Author | Song Baoyin| Inaba, Hideo| Horibe, Akihiko| Takahashi Takashi| |
| Abstract | The experiment for investigating the falling snow melting characteristics of warm water flowing along sheet channels spread on a roof was performed in Tookamachi city, Nigata prefecture from February 6 to February 7, 1995. The sheet surface temperatures at 11 positions in 3 channels were measured. A physical model for a gas-water-snow system was constructed to compare the predicted results with the measured ones. A fully spread uniform water film in the sheet channel was observed in the experiments. The experimental results elucidated that it was feasible to use warm water flowing along sheet channels for melting falling snow on roofs. The temperature drop in the sheet channel mainly depended on the snowfall intensity, atmospheric temperature and wind speed. Under the influence of the roof edge, the temperature drop in the channel next to the side edge was much larger than that in middle channels. A water-snow two phase flow or a snow covered frozen water was experienced temporarily in the lower reaches of the water flowing channel. These suggest that a larger water flow rate is needed for the channel next to the roof edge, and a higher inlet temperature or a greater water flow rate is required for a severe weather condition. There was reasonably good agreement between the measured and predicted water temperatures. |
| Publication Title | Memoirs of the Faculty of Engineering, Okayama University |
| Published Date | 2000-03-27 |
| Volume | volume34 |
| Issue | issue1-2 |
| Start Page | 1 |
| End Page | 12 |
| ISSN | 0475-0071 |
| language | English |
| File Version | publisher |
| NAID | 120002307686 |
| JaLCDOI | 10.18926/15356 |
|---|---|
| FullText URL | Mem_Fac_Eng_OU_34_13.pdf |
| Author | Sakakibara, Akira| Tanimoto, Tadashi| Matsushima, Takahisa| Hosokawa, Norio| Kanadani, Teruto| |
| Abstract | Repeated tensile fatigue strength of the low temperature age-hardened Al-Zn alloys is investigated varying the specimen thickness. Fatigue strength of the age-hardened specimens decreases with the specimen thickness when the specimen is thinner than a certain thickness, whereas fatigue strength of non age-hardened specimens, i.e., pure aluminum and dilute Al-Zn alloy, does not depend the specimen thickness. The dependence of fatigue strength on the thickness of age-hardened specimen is considered to be caused by the decrease of the strength of specimen as a whole, as a result of increase in volume ratio of the soft surface layer formed after age-hardening with decreasing specimen thickness. |
| Publication Title | Memoirs of the Faculty of Engineering, Okayama University |
| Published Date | 2000-03-27 |
| Volume | volume34 |
| Issue | issue1-2 |
| Start Page | 13 |
| End Page | 17 |
| ISSN | 0475-0071 |
| language | English |
| File Version | publisher |
| NAID | 120002307815 |
| JaLCDOI | 10.18926/15359 |
|---|---|
| FullText URL | Mem_Fac_Eng_OU_34_19.pdf |
| Author | Okada, Akira| Uno, Yoshiyuki| Okajima, Isao| |
| Abstract | In EDM, the machining characteristics greatly depend on the energy distribution. Therefore, it is very important to clarify the energy distribution for understanding various phenomena in EDM. In this paper, the energy distribution in EDM with graphite electrode is investigated by measuring the temperatures of electrode and workpiece. Experimental analysis shows that the material removal rate depends on energy density while the electrode wear greatly depends on the adhesion of heat resolved carbon from machining fluid, and the energies distributed into electrode and workpiece are almost constant regardless of pulse duration. |
| Publication Title | Memoirs of the Faculty of Engineering, Okayama University |
| Published Date | 2000-03-27 |
| Volume | volume34 |
| Issue | issue1-2 |
| Start Page | 19 |
| End Page | 26 |
| ISSN | 0475-0071 |
| language | English |
| File Version | publisher |
| NAID | 120002307707 |
| JaLCDOI | 10.18926/15360 |
|---|---|
| FullText URL | Mem_Fac_Eng_OU_34_27.pdf |
| Author | Wei, He| Koga, Ryuji| Iokibe, Kengo| Wada, Osami| Toyota, Yoshitaka| |
| Abstract | In spring of 1998, Asian dust was observed with a Mie LIDAR in Okayama University, which can measure depolarization ratio. Three events of intense Asian dust were occurred in the period and medially detailed structure of atmosphere was found after examining records. Asian dust was distinguished from water droplets and the possibility to study three dimensional dynamic structure of atmosphere were demonstrated. |
| Keywords | Mie lidar Asian dust (KOSA) depolarization ratio backscattering ratio range normalized |
| Publication Title | Memoirs of the Faculty of Engineering, Okayama University |
| Published Date | 2000-03-27 |
| Volume | volume34 |
| Issue | issue1-2 |
| Start Page | 27 |
| End Page | 37 |
| ISSN | 0475-0071 |
| language | English |
| File Version | publisher |
| NAID | 120002307539 |
| JaLCDOI | 10.18926/15363 |
|---|---|
| FullText URL | Mem_Fac_Eng_OU_34_39.pdf |
| Author | Hayakawa, Satoshi| Shirosaki, Yuki| Yabuta, Takeshi| Tsuru, Kanji| Ohtsuki Chikara| Osaka, Akiyoshi| |
| Abstract | Silicone elastomer was chemically treated at 60℃ for 7 days with 30 wt% H(2)O(2) solutions with or without TaCl(5) and soaked for various periods in a simulated body fluid(Kokubo solution) up to 21 days. Apatite formation ability of the surface of the silicone elastomer specimens was investigated with thin-film X-ray diffraction and FT-IR reflection spectroscopy. These silicone specimens did not deposit apatite or calcium phosphates, irrespective of chemical treatment. Osteoblast-like cells (MC3T3-El) derived from mouse were cultured on the specimens at 36.5℃ under 5%C0(2) and 95% humidity. Similar degree of proliferation of cells was observed at 7 days among three specimens, while the no treatment specimen after incubation for 5 days showed a lower degree of proliferation than the silicone treated with 30 wt% H(2)O(2) solutions with or without TaCl(5). Alkaline phosphatase activity of the cells proliferated on the no treatment specimen was lower than those of the silicone treated with 30 wt% H(2)O(2) solutions with or without TaCl(5). These results indicate that the cytotoxicity of the silicone could be improved by the chemical treatment with 30 wt% H(2)O(2) solutions with or without TaCl(5). |
| Publication Title | Memoirs of the Faculty of Engineering, Okayama University |
| Published Date | 2000-03-27 |
| Volume | volume34 |
| Issue | issue1-2 |
| Start Page | 39 |
| End Page | 43 |
| ISSN | 0475-0071 |
| language | English |
| File Version | publisher |
| NAID | 120002308019 |
