start-ver=1.4 cd-journal=joma no-vol=62 cd-vols= no-issue=SJ article-no= start-page=SJ1002 end-page= dt-received= dt-revised= dt-accepted= dt-pub-year=2023 dt-pub=20230125 dt-online= en-article= kn-article= en-subject= kn-subject= en-title= kn-title=Reconfigurable waveguide based on valley topological phononic crystals with local symmetry inversion via continuous translation en-subtitle= kn-subtitle= en-abstract= kn-abstract=We proposed a reconfigurable valley topological acoustic waveguide constructed using a 2D phononic crystal (PnC) with C3v symmetric arrangement of three rods in the unit cell. An interface between two types of PnCs with differently oriented unit cells exhibits high robustness of the valley transport of acoustic waves via the topologically protected state. Structural reconfiguration was introduced by the continuous translation of rod arrays in the PnCs. The topological phase transition in this translational change was quantitatively identified by the change in the Berry curvature. The translation of the rods leaves a dimer array at the interface, creating a localized/defective mode along the waveguide. Despite the presence of the localized mode, the acoustic wave can propagate along the reconfigurable waveguide the same as the original waveguide. The continuous translation of a rod array can be used to turn on and off the bandgap. This can be a new approach to design a robust acoustic device with a high reconfigurability. en-copyright= kn-copyright= en-aut-name=AliMd. Shuzon en-aut-sei=Ali en-aut-mei=Md. Shuzon kn-aut-name= kn-aut-sei= kn-aut-mei= aut-affil-num=1 ORCID= en-aut-name=KataokaMotoki en-aut-sei=Kataoka en-aut-mei=Motoki kn-aut-name= kn-aut-sei= kn-aut-mei= aut-affil-num=2 ORCID= en-aut-name=MisawaMasaaki en-aut-sei=Misawa en-aut-mei=Masaaki kn-aut-name= kn-aut-sei= kn-aut-mei= aut-affil-num=3 ORCID= en-aut-name=TsurutaKenji en-aut-sei=Tsuruta en-aut-mei=Kenji kn-aut-name= kn-aut-sei= kn-aut-mei= aut-affil-num=4 ORCID= affil-num=1 en-affil=Department of Electrical and Electronic Engineering, Okayama University kn-affil= affil-num=2 en-affil=Department of Electrical and Electronic Engineering, Okayama University kn-affil= affil-num=3 en-affil=Department of Electrical and Electronic Engineering, Okayama University kn-affil= affil-num=4 en-affil=Department of Electrical and Electronic Engineering, Okayama University kn-affil= END start-ver=1.4 cd-journal=joma no-vol=62 cd-vols= no-issue=SJ article-no= start-page=SJ0803 end-page= dt-received= dt-revised= dt-accepted= dt-pub-year=2023 dt-pub=20230427 dt-online= en-article= kn-article= en-subject= kn-subject= en-title= kn-title=Acoustic metasurfaces and topological phononics for acoustic/elastic device design en-subtitle= kn-subtitle= en-abstract= kn-abstract=This paper reviews recent progress in acoustic metasurfaces and the novel concept of "topological acoustic/phononics" for designing compact yet efficient acoustic devices. After a brief review of this research area and its impact on ultrasonic technologies, some of the efforts to develop highly efficient sound absorption devices using acoustic metasurfaces are introduced. A resonance-based mechanism to achieve efficient absorption in metasurface structures thinner than the wavelength of the incident sound is briefly discussed, and its extensions to a broad spectrum are highlighted. Next, a valley topological phononic system is introduced, and its applications to the design of phononic waveguides are exemplified. The band structure design for extracting topologically protected edge modes is shown together with a numerical and experimental demonstration of the robustness of phononic waveguides constructed in both acoustic and elastic regimes. en-copyright= kn-copyright= en-aut-name=TsurutaKenji en-aut-sei=Tsuruta en-aut-mei=Kenji kn-aut-name= kn-aut-sei= kn-aut-mei= aut-affil-num=1 ORCID= affil-num=1 en-affil=Department of Electrical and Electronic Engineering, Okayama University kn-affil= END