Mem_Fac_Eng_OU_23_2_9.pdf 284 KB
Kuroda Tsutomu Tosco Co. LTD.
大崎 紘一 Department of Mechanical Engineering
松田 正明 Department of Mechanical Engineering
Fujisawa Keita Mitsubishi Electric Co., LTD.
Multi-item flexible manufacturing systems have been spread to correspond the short life-cycle and the diversification of products. Part handling plays an important role to operate multi-functional robot efficiently in these systems, and many jigs are widely used to hold a part. They should be exchanged at once according to changing products. In this paper, we propose a pin jig which holds a part with two pins, and design method of the position, length and diameter of those pins for a cylindrical part. This jig has the following characteristics. As a surface of the jig is inclined to use gravity, the part can be fixed without any external forces. Therefore the structure of jig becomes simple, and loading and unloading of a part becomes easy for a robot hand.
Memoirs of the Faculty of Engineering, Okayama University
Faculty of Engineering, Okayama University
|Eprints Journal Name||