このエントリーをはてなブックマークに追加
ID 42677
フルテキストURL
タイトル(別表記)
Material recycling of inorganic sludge by wet ball milling
著者
崎田 真一 岡山大学環境管理センター Kaken ID researchmap
黒田 龍介 岡山大学環境理工学部環境物質工学科
紅野 安彦 岡山大学環境理工学部環境物質工学科 Kaken ID publons
難波 徳郎 岡山大学環境理工学部環境物質工学科 ORCID Kaken ID publons researchmap
抄録
The possibility of material recycling of inorgamic sludge by wet ball milling with distrilled water and an ethylenediaminetetraacetic acid disodium salt dehydrate (EDTA・2Na・2H(2)O)reagent was investigated. The inorganic sludge consisted of 14.1mass% of the heat-treated sludge obtained after drying and heat treatment, 20.1mass% of active carbon, and 65.9mass% of water. The wet ball milling of the heat-treated sludge was performed using a ball pot and balls in air for 40 h at room temperature with the rotational speed fixed at 200rpm. The fractions of Mn, Fe, Ni, Cu, and Zr in the specimens obtained by wet-ball-milling the heat-treated sludge decreased and those of Si and Al increased. Appropriate content of distilled water and weight of the heat-treated sludge for wet ball milling were 150-250 ml and 4.5 g or less, respectively. When the wet ball milling of the heat-treated sludge was perfomed twice,the fractions of Mn, Fe, Ni, Cu, and Zr in the specimen obtained after repeated wet ball milling remarkably decreased and that of Si increased in comparison with those in the specimens wet-ball-milled once. This suggests that the repeat of wet ball milling of the heat-treated sludge leads to a colorless specimen without colored ions such as Mn, Fe, Ni, and Cu.
キーワード
Inorganic sludge
EDTA
Wet ball milling
Recycling
備考
論文
発行日
2009-12
出版物タイトル
環境制御
出版物タイトル(別表記)
Environmental Research & Control
31巻
出版者
岡山大学環境管理センター
出版者(別表記)
Environmental Management Center, Okayama University
開始ページ
26
終了ページ
31
ISSN
0917-1533
NCID
AN1024789X
資料タイプ
紀要論文
言語
日本語
論文のバージョン
publisher
査読
有り
Eprints Journal Name
erc