Memoirs of the Faculty of Engineering, Okayama University
Published by Faculty of Enginerring, Okayama University

<Formerly known as>
Memoirs of the School of Engineering, Okayama University

<Availability>
Some items are not available because of decision by its author or publisher.

Application of Sequential Quadratic Programming Method toTemperature Distribution Control in Reactor Furnace

石丸 和史 Division of Electronic and Information System Engineering Graduate School of Natural Science and Technology
小西 正躬 Dept. of Electrical and Electronic Engineering Okayama
今井 純 Dept. of Electrical and Electronic Engineering Okayama
西 竜志 Dept. of Electrical and Electronic Engineering Okayama
抄録
In reactor furnace, due to high temperature and high pressure, data can be measured only near the furnace wall. In this paper, the way to estimate temperature distribution in a reactor furnace using measured data near the furnace walls and to control temperature distribution to the desired temperature distribution was studied. In the estimation, SQP method is employed using measured data near the furnace walls. As the result, the whole temperature distribution in a furnace could be obtained from such limited data. Furthermore, to control the temperature distribution in a reactor furnace, gas flow from multiple tuyeres and supplying material for controlling temperature distribution in a reactor furnace were determined by the SQP method. It was shown that temperature distribution in a furnace was regulated to achieve various desired distribution. Thus, it was verified that complicated temperature distribution in a reactor furnace could be controlled by combining furnace simulation and SQP method.
ISSN
0475-0071
NCID
AA10699856